PROFESSIONAL R&D TEAM
AquaCrest has professional experienced R&D team which have access to an advanced laboratory and are always pursuing the best product quality.
PERFECTLY FIT THE ORIGINAL
Wonderful design and perfectly fit the original brand. Easy installation and operation.
Raised groove polypropylene construction for better water purity.
BETTER WATER MAKES BETTER LIFE
AquaCrest makes better life. With AquaCrest filters, it’s easier than ever to enjoy better tasting water that’s better for you. AquaCrest filters cut the taste and odor of chlorine while reducing impurities that can adversely affect your health over time.
|Used In Brands||Culligan|
|Primary Filter Media||Activated Carbon|
|Degree of filtration||25 micron|
|Filter Life (gallons)||15000|
|Filter Life (liters)||56,5781|
|Filter Life (months)||6 months|
|Operating Temperature (°F)||40 - 180|
|Operating Temperature (°C)||4.4 - 68|
|Flow Rate (gpm)||3|
|Flow Rate (lpm)||11|
|Warranty Guarantee||Unconditional Product Guarantee for Life of the Product|
1. Turn off water supply to filter. Depress red pressure-relief button on top of filter. Use wrench to unscrew bottom of housing.
NOTE: If turning off water supply to filter will also turn off water supply to the rest of the home, be sure to fill a bucket of water first to allow you to clean housing after it has been removed.
2. Locate and remove large O-ring. wipe clean of lubricant and set aside. Discard used cartridge. Rinse out bottom of housing and fill about 1/3 full with water. Add about 2 tablespoons of bleach and scrub cap and bottom of housing with nonabrasive sponge or cloth. Rinse thoroughly. Lubricate O-ring with clean silicone grease. Insert O-ring back into groove and smooth into place with finger. Insert new cartridge over standpipe in bottom of housing.
3. Screw bottom of housing onto the cap and hand-tighten. DO NOT OVER-TIGHTEN.
Turn on water supply slowly to allow filter to fill with water. Depress red pressure-relief button to release trapped air. Check for leaks before leaving installation.
NOTE: After installation, flush the cartridge for 10 minutes, wait one hour, then flush again for 10 minutes
before using the water.