< img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=148742999096938&ev=PageView&noscript=1" />

Waterdrop LT700P Refrigerator Water Filter

In stock


* Required Fields

read more >


The carbon components used in Waterdrop filters could contribute to the reduction of chlorine taste and odor while retaining minerals beneficial to health.
With an NSF certified water filter, you can rest assured that you are getting only the best of the best. These water filters are put through rigorous testing to ensure that only the purest, freshest water.
Unique, premium coconut carbon block gives you fresh water and leaves beneficial minerals which may be beneficial to health.
Every time you purchase a Waterdrop filter, you’ll provide a child with One Day supply of clean water. Starting March 22. 2017, Waterdrop will donate part of profit from every purchased filter to help build water projects and sanitation facilities.

Technical Information

Used In Brands LG  / Beko / Kenmore
Manufacturer's Id WD-LT700P
Media Coconut Carbon
Primary Filter Media Activated Carbon Block
Filter Life (gallons) 200
Filter Life (liters) 757
Filter Life (months) 6 months
Operating Pressure (psi) 30 - 100
Operating Temperature (°F) 33 - 100
Operating Temperature (°C) 0.6 - 38
Flow Rate (gpm) 0.5
Flow Rate (lpm) 1.9
Certifications Filter cartridge has been Tested and Certified by NSF International against NSF/ANSI 42 for materials and structural integrity requirements
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
The WD-LT700P is comparable with the following part numbers
LT700P ADQ36006101 ADQ36006101-S ADQ36006101S
ADQ36006102 ADQ36006102-S ADQ36006102S 048231783705
4394650100 4874960100 5699983
9690 46-9690


1. Push button to open filter cover.

2. Pull cartridge down. Pull out the filter.

NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.

3. Holding new filter, remove the packaging and end-cap.

4. Insert the new filter into the manifold hole until it stops.

NOTE: If the filter is very hard to rotate, please insert the filter a bit towards the filter receiver.

5. Push the cover back up until it clicks into place.

6. Run water from the dispenser for 5 minutes at 0.5 gpm (about 21/2 gallons) to clear the system and prevent sputtering.

NOTE: Initial flow rate may be slower than expected.Full flow rate should be restored within 24-36 hours.

7. Reset the indicator light by holding down the LIGHT/FILTER button for 3 seconds.

8. Check filter for any leaks. If leaks are detected, uninstall and reinstall the filter as instructed above.



Write Your Own Review

You're reviewing: Waterdrop LT700P Refrigerator Water Filter

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars